Victory Victory Judge Manuel d'instructions télécharger pdf

® 23801 E. La Palma Ave., Yorba Linda, Ca 92887 Ph. 714.692.8180, Fax. 714.692.5016

www.fi2000r.com

06/12

* Cobra® recommends you always wear a helmet while riding. Please never operate your motorcycle while under

the influence of alcohol and/or drugs. Enjoy the new look of your motorcycle and please ride safely.

Items Supplied >

1 – POWRPRO™ Fuel Injection Module

6 – Zip Ties 8”

2 – Zip Ties 2”

1 – Velcro Stripe

Application(s) >

Vegas 8-Ball 2008 – 2013

Victory High Ball 2012 - 2013

Victory Judge 2013

Hammer 8 Ball 2008 – 2013

Vegas 2008 – 2012

Kingpin 2008 – 2012

Zach Ness Vegas 2011 – 2012

Vegas Jackpot 2008 – 2013

Hammer S 2008 – 2012

Boardwalk 2013

Instruction Manual >

Read all instructions carefully and completely before installing your new Fi2000AT

module. It is

recommended that a qualified mechanic or technician install this product.

1. Remove seat which is retained by three bolts in rear of pad on some models, the plastic seat cover may

need to be removed on some models to access the socket head shoulder screws. On the Judge model,

both side number plate covers must be removed, and two M8 bolts removed from under the seat. Four

remaining seat bolts must also be removed, by removing the left and right rear fender rails from the bike.

2. On most models, remove the single bolt retaining rear of fuel tank along with the bolts and covers securing

front of fuel tank to frame. The Judge model will need to have two bolts removed from the rear of the tank,

along with the front tank mount covers and bolts.

3. Prop rear of fuel tank up and disconnect quick release fuel coupling on bottom of tank, by pressing in

green tabs on each side of coupler and pulling fuel coupling downward from tank. Disconnect the fuel tank

electrical connector along bottom of fuel tank also, see Figure 1. Be sure to disconnect two vacuum lines

from rear lower left corner of fuel tank, for tank removal, see Figure 2.

4. Assistance is recommend to carefully pull fuel tank upward and rearward at the same time to remove it.

Set fuel tank in a secure location to prevent it from being damaged, while it is removed.

5. Remove left and right side covers on the engine between the front and rear cylinders for additional engine

access. Note the Judge models, must have the covers unscrewed, all other models, snap off.

6. Locate the rear fuel injector connector between engine heads, from right side of motorcycle, see Figure 3.

Pull the "RED" pull tab up towards the top portion of the connector, assistance will be needed to prevent the

injector from rotating during this procedure, see Figure 4. Once the Red tab is pulled upward, push in on

the black tab below it, see Figure 4 & 5. While pushing in on black tab, pull entire connector upward and

remove from injector. It may be necessary to snip the zip tie from the injector wires to the fuel rail, to allow

adequate wire length to free connector from injector. Pull injector connector outward towards right side of

motorcycle, for installation of Powrpro Tuner™ (PPT) connectors later in instructions.

7. Repeat injector connector removal procedures for front connector, noting that "RED" pull tab is accessed

from left side of motorcycle, see Figure 4 & 5. Once connector is removed from front injector, be sure to

pull it outward towards right side of motorcycle.

8. Place Powrpro Tuner™ (PPT) module on top of motorcycle frame in under seat area, Figure 6.

9. Route Fuel injector connectors along right upper frame rail. The longer of the two connector pairs will go to

the front injector. The shorter pair to the rear injector. Mate the shorter female PPT connector to the rear

injector and the corresponding male PPT connector to the original rear Victory female connector, see

Figure 7. Be sure all connectors are snapped into place and the "RED" lock tab on the Victory female is

secured into original position, as it was prior to disassembly, Figure 7.

92-1052-AT

Page 1 of 5

DOCUMENT NO. 0017 REV. A

1 2 3 4 5

Résumé du contenu

Page 1 - Instruction Manual >

® 23801 E. La Palma Ave., Yorba Linda, Ca 92887 Ph. 714.692.8180, Fax. 714.692.5016 www.fi2000r.com 06/12 1 * Cobra® recommends you always we

Page 2

® 23801 E. La Palma Ave., Yorba Linda, Ca 92887 Ph. 714.692.8180, Fax. 714.692.5016 www.fi2000r.com 06/12 2

Page 3

® 23801 E. La Palma Ave., Yorba Linda, Ca 92887 Ph. 714.692.8180, Fax. 714.692.5016 www.fi2000r.com 06/12 3 Instruction Manual > 92-1052-A

Page 4

® 23801 E. La Palma Ave., Yorba Linda, Ca 92887 Ph. 714.692.8180, Fax. 714.692.5016 www.fi2000r.com 06/12 4

Page 5

® 23801 E. La Palma Ave., Yorba Linda, Ca 92887 Ph. 714.692.8180, Fax. 714.692.5016 www.fi2000r.com 06/12 5 Instruction Manual > 92-

Commentaires sur ces manuels

Pas de commentaire

Victory Victory Judge Manuel d'instructions

Naviguer en ligne ou télécharger Manuel d'instructions pour Motocyclettes Victory Victory Judge. Victory Victory Judge Instruction manual [en] Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Motocyclettes Victory Victory Judge