Victory Hammer S Manuel du propriétaire télécharger pdf (Page 74)

Maintenance

Seat Removal (HAMMER S)

WARNING! A loose seat could cause a sudden shift

in riding position, causing loss of control. Always

ensure seats are secure before riding.

1. Remove the passenger seat cowl by pulling

evenly and directly upward on both sides

of the cowl.

2. Remove the three socket head seat screws using a 5 mm hexagonal wrench.

3. Lift the rear of the seat and pull rearward to disengage the tab at the front of the seat.

Seat Installation (HAMMER S)

1. Slide the seat tongue into the receiver at the rear of the fuel tank. Align the seat screw

holes. Ensure the front seat mount is engaged in the front receiver, then install the

screws. Torque to 57 in. lbs. (6.8 Nm).

2. Reinstall the passenger seat cowl.

Seat Removal (JACKPOT)

WARNING! A loose seat could cause a sudden shift in riding position,

causing loss of control. Always make sure the seats are securely

fastened before riding the motorcycle.

1. Remove the side covers. If necessary, remove the fuse box

from the bracket.

2. Remove the three screws securing the seat to the frame. Lift

the rear of the seat and pull rearward and upward to remove it.

Seat Installation (JACKPOT)

1. Slide the seat tongue into the rubber mount at the rear of the

fuel tank. Push down on the rear of the seat until the screw

holes align.

2. Ensure the front seat mount is engaged in the front rubber

mount, then install the screws and tighten securely.

3. Reinstall the fuse box (if removed). Reinstall the side covers.

Seat Screws

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 109 110

Pas de commentaire

Victory Hammer S Manuel du propriétaire Page 74