Victory Hammer S Manuel du propriétaire télécharger pdf (Page 81)

Maintenance

Headlight Lamp Replacement

High intensity discharge (HID) lamps, if equipped, should be handled only by a trained tech-

nician wearing the appropriate protective gear. See the VICTORY Service Manual or an

authorized VICTORY dealer.

Halogen Lamps

1. Unplug the wiring harness from the back of the headlight (lift the tab). Be sure to pull on

the connector, not on the wiring.

Tip: Avoid touching a halogen lamp with bare fingers. Oil from your skin leaves a residue, causing a hot

spot that will shorten the life of the lamp. If a lamp is touched, clean it thoroughly with denatured

alcohol.

2. Remove the spent lamp. Apply dielectric grease to the socket and install a new lamp.

3. Reinstall the wiring harness.

Sidestand Lubrication

1. Secure the motorcycle in a fully upright position

using an appropriate motorcycle lift or a block of

wood or steel placed securely under the frame.

2. Move the sidestand upward to its stored position.

CAUTION! Wear face protection. The sidestand return spring

is under tension and can injure your eyes and face when

released.

3. Hold the nut and remove the sidestand pivot bolt

and sidestand return spring. Wipe any old grease

and dirt from the sidestand, frame and pivot bolt.

4. Lubricate the sidestand, the pivot bolt and the ends of the spring with VICTORY All

Purpose Grease or equivalent.

5. Reinstall the sidestand spring and place the sidestand on the mounting boss with the

stand in the stored (up) position. Install the pivot bolt and tighten it while holding the

nut.

Torque: 35 ft-lbs (47 Nm)

6. Verify that the sidestand moves freely through its pivot range.

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 109 110

Pas de commentaire

Victory Hammer S Manuel du propriétaire Page 81