Victory Hammer S Manuel du propriétaire télécharger pdf (Page 77)

Maintenance

Handlebar Position (HIGH-BALL)

On models equipped with two handlebar positions, the motor-

cycle is manufactured with handlebars in the low position.

Before changing handlebar position, check regulations in your

area of operation. Operation with the handlebars in the high

position may not be legal in all areas or for all riders.

WARNING! Handlebar controls must be repositioned each time

handlebar position is changed. Failure to reposition handlebar controls

could result in loss of vehicle control resulting in severe injury or death.

1. To adjust handlebar position, loosen

the bolts on the bottom of the riser.

2. Adjust the handlebars upward or

downward to the desired position.

For high position, align the upper

handlebar marks with the split in

the riser. For low position, align the

lower handlebar marks with the

split in the riser.

3. Tighten the front (longer) riser bolts first, then

tighten the rear bolts.

Torque: 22 ft-lbs (31 Nm)

4. Loosen the screws at the bottom of the left and

right handlebar controls and reposition both

controls. Make sure the index pin in each

control is fully seated in the appropriate

handlebar hole before tightening screws. For

handlebars in the low position, seat the index

pins in the forward set of index holes. For

handlebars in the high position, seat the pins in

the rear set of holes.

5. Tighten the handlebar control screws.

Torque: 25 in-lbs (2.8 Nm)

High

Position

Low

Position

High

Position

Align upper

mark to split.

Low

Position

Align lower

mark to split.

Low Position

Use forward holes.

High Position

Use rear holes.

Index Pin

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 109 110

Commentaires sur ces manuels

Pas de commentaire

Victory Hammer S Manuel du propriétaire Page 77

Commentaires sur ces manuels

Produits connexes et manuels pour Motocyclettes Victory Hammer S