Victory Hammer S Manuel du propriétaire télécharger pdf (Page 42)

Pre-Ride Inspections

Rear Brake Pedal

Press and release the rear brake pedal. It should

move freely and smoothly, and it should return to

its rest position quickly when released. You

should feel a firm resistance in the pedal within

the first 3/8 inch (8 mm) of pedal travel.

If the brake pedal fails to perform as stated or

travels too far before beginning to engage the

brake, see the VICTORY Service Manual, or con-

tact an authorized VICTORY dealer for service.

Brake Pedal Gap

This procedure does not apply to JUDGE.

With the brake pedal in the relaxed position, and

with the master cylinder piston positioned against

the internal stop, measure the distance between

the brake pedal stop and the foot peg mount. The

gap should be 2-5 mm. Make adjustments as

needed.

1. Hold the clevis to prevent it from bending.

Loosen the brake linkage rod lock nut.

2. Turn the linkage rod in or out as necessary.

3. Hold the clevis and tighten the lock nut

securely against the clevis.

4. Verify that the gap is 2-5 mm.

5. Verify that the rear wheel rotates freely

through the full freeplay range of pedal

without dragging or binding. If drag is present

with the pedal released, refer to the VICTORY

Service Manual or contact an authorized

Victory dealer.

8 mm

Brake Pedal

Stop

Foot Peg Mount

Clevis

Lock Nut

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 109 110

Pas de commentaire

Victory Hammer S Manuel du propriétaire Page 42